DTC B1795 Occupant Classification ECU Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1795 |
|
|
| 1.CHECK DTC |
Turn the ignition switch on (IG), and wait for at least 10 seconds.
Check for DTCs (Click here).
|
| ||||
| B | |
| 2.REPLACE OCCUPANT CLASSIFICATION ECU |
Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery.
Replace the occupant classification ECU (Click here).
| NEXT | |
| 3.PERFORM ZERO POINT CALIBRATION |
Connect the negative (-) terminal cable to the battery.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Using Techstream, perform "zero point calibration" (Click here).
| NEXT | |
| 4.PERFORM SENSITIVITY CHECK |
Using Techstream, perform "sensitivity check" (Click here).
| NEXT | ||
| ||