Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > PRECAUTION

for Preparation Click here



NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected.

System Name
See procedure
Power Back Door System
Click here


1.PRECAUTION FOR HEADLIGHT BULB REPLACEMENT
  1. If even a thin film of oil is left on the surface of the halogen light, the bulb may be damaged because the light will operate at a higher temperature.

  2. Handle any halogen light with great care. Dropping, hitting or damaging the bulb, in any way, may result in exploding and shattering because of the high internal pressure.

  3. Always prepare a new bulb for immediate replacement. While replacing the bulb, the lens may attract dust and moisture if removed from the vehicle for too long.

  4. Always use a bulb of the same wattage for replacement.

  5. Securely reinstall the socket after bulb replacement.
    The lens may become cloudy or the light cavity may fill with water through gaps around the socket if not installed correctly.


2.EXPRESSIONS OF IGNITION SWITCH
  1. The type of ignition switch used on this model differs according to the specifications of the vehicle.
    The expressions listed in the table below are used in this section.

    Switch Type
    Ignition Switch (position)
    Engine Switch (condition)
    Expression
    Ignition switch off
    LOCK
    Off
    Ignition switch on (IG)
    ON
    On (IG)
    Ignition switch on (ACC)
    ACC
    On (ACC)
    Engine start
    START
    Start