OCCUPANT CLASSIFICATION ECU > INSTALLATION |
| 1. INSTALL OCCUPANT CLASSIFICATION ECU |
![]() |
Install the occupant classification ECU with the claw.
Connect the 2 connectors.
| 2. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat) |
| 3. INSPECT FRONT SEAT SLIDE ADJUSTER LOCK (for Manual Seat) |
During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.
If the seat adjusters do not lock simultaneously, loosen the bolts securing the seat to adjust the adjuster position.
| 4. INSTALL REAR SEAT TRACK COVER RH (for Manual Seat) |
| 5. INSTALL FRONT INNER SEAT TRACK COVER RH (for Manual Seat) |
| 6. INSTALL FRONT OUTER SEAT TRACK COVER RH (for Manual Seat) |
| 7. INSTALL FRONT SEAT HEADREST ASSEMBLY RH (for Manual Seat) |
| 8. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat) |
| 9. INSTALL REAR INNER SEAT TRACK COVER RH (for Power Seat) |
| 10. INSTALL REAR OUTER SEAT TRACK COVER RH (for Power Seat) |
| 11. INSTALL FRONT INNER SEAT TRACK COVER RH (for Power Seat) |
| 12. INSTALL FRONT OUTER SEAT TRACK COVER RH (for Power Seat) |
| 13. INSTALL FRONT SEAT HEADREST ASSEMBLY RH (for Power Seat) |
| 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for Manual Seat) |
| 15. INSPECT FRONT SEAT ASSEMBLY (for Manual Seat) |
w/Seat Heater System:
Check the seat heater operation.
Turn the ignition switch on (IG).
Turn the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.
| 16. INSPECT FRONT SEAT ASSEMBLY (for Power Seat) |
Inspect the power seat operation.
w/ Seat Heater System:
Check the seat heater operation.
Turn the ignition switch on (IG).
Turn the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.
| 17. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).