FRONT SEAT OUTER BELT ASSEMBLY > INSTALLATION |
| 1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
![]() |
Engage the adjuster positioning hole with the claw and install the front shoulder belt anchor adjuster assembly with the 2 bolts.
| 2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Temporarily install the front seat outer belt assembly with the 2 bolts.
Fully tighten the bolt <A> first, then the bolt <B> to install the front seat outer belt assembly.
![]() |
Connect the connector and lock the locking button as shown in the illustration.
![]() |
Connect the shoulder anchor of the front seat outer belt assembly with the nut.
| 3. INSTALL CENTER PILLAR GARNISH |
![]() |
Engage the 2 guides and the clip.
Install the center pillar garnish LH with the clip and screw.
| 4. CONNECT FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Install the floor end of the front seat outer belt assembly with the bolt.
Check if the ELR locks.
With the belt assembly installed, check that the belt locks when it is pulled out quickly.
| 5. INSTALL LOWER CENTER PILLAR GARNISH |
![]() |
Engage the 2 claws and the 2 clips, and install the lower center pillar garnish LH.
| 6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Align the alignment mark (red) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
| 7. INSTALL REAR DOOR SCUFF PLATE |
![]() |
Engage the guide, 3 clips and 5 claws, and install the rear door scuff plate LH.
| 8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Align the alignment mark (blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.
| 9. INSTALL FRONT DOOR SCUFF PLATE |
![]() |
Engage the guide and the 8 claws, and install the front door scuff plate LH.
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. INSPECT SRS WARNING LIGHT |