Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › PTC HEATER RELAY

PTC HEATER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE PTC HEATER RELAY
  1. Remove the 3 PTC heater relays to the engine room No. 2 relay block.



3. INSPECT PTC HEATER RELAY


A092673E05
  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    1. If the result is not as specified, replace the relay.



4. INSTALL PTC HEATER RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.