Home › RESTRAINTS › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


DESCRIPTION

When the ignition switch is on (IG), the center airbag sensor assembly transmits front seat inner belt status signals to the combination meter assembly through CAN. If the driver seat belt is not fastened, the combination meter assembly blinks the driver seat belt warning light. If the seat belt is fastened, the warning light goes off.

NOTICE:
The seat belt warning system uses CAN. Before troubleshooting the seat belt warning system, perform "COMMUNICATION FUNCTION CHECK" by following "HOW TO PROCEED WITH TROUBLESHOOTING" to confirm that the communication systems are normal.


WIRING DIAGRAM


B177940E01


INSPECTION PROCEDURE

1.CHECK FOR DTCs
  1. Check for DTCs.

Result:
Result
Proceed to
Output DTC (CAN communication)
A
Output DTC (Airbag system)
B
No output DTC
C



A
GO TO CAN COMMUNICATION SYSTEM (Click here)

B
GO TO AIRBAG SYSTEM (Click here)
C


2.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Operate Techstream according to the steps on the display and select "ACTIVE TEST".


Combination Meter:

Tester Display
Test Part
Control Range
Diagnostic Note
Driver Side Seat Belt
Driver side seat belt warning light
Driver side seat belt warning light is OFF / ON
Confirm that the vehicle is stopped, engine idling

OK:
Switch condition (ON/OFF) can be switched by "ACTIVE TEST".



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

END