Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking of the SRS warning light.

HINT:
  1. When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
  2. A DTC output mode signal is transmitted through the CAN communication system to each ECU including the center airbag sensor assembly. Thus when all systems do not enter DTC output mode, there may be an ECM malfunction.


WIRING DIAGRAM


C178541E02


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Use Techstream to check if the CAN communication system is functioning normally.

    HINT:
    1. Refer to "Bus Check" of the CAN communication system (Click here).
    2. The center airbag sensor assembly is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.

    Result:
    Condition
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK WIRE HARNESS (TC OF DLC3 - TC OF ECM)


    C126742E85
  1. Turn the ignition switch off.

  1. Disconnect the connector from the ECM.



    C178312E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E11-13 (TC) - A50-27 (TC)
    Always
    Below 1 Ω



NG
REPLACE WIRE HARNESS
OK


3.CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND)


    C126742E86
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E11-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPLACE WIRE HARNESS
OK


4.CHECK WIRE HARNESS (TC OF DCL3 - BODY GROUND)


    C126742E85
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E11-13 (TC) - Body ground
    Always
    1 MΩ or higher



NG
REPLACE WIRE HARNESS OR EACH ECU
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)