DTC P0793 Intermediate Shaft Speed Sensor "A" |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0793 | ECM detects conditions (a), (b) and (c) continuously for 5 sec. or more: (1-trip detection logic)
|
|

| Terminal | NC+ - NC- |
| Tool setting | 1 V/DIV, 1ms/DIV |
| Vehicle condition | Vehicle speed 30 km/h (19 mph): (3rd gear) Engine speed 1400 rpm |
| Related DTCs | P0793: Speed sensor (NC)/Verify pulse input |
| Required sensors/Components | Speed sensor (NC), Speed sensor (NT), Park/neutral position switch |
| Frequency of operation | Continuous |
| Duration | 5 sec. |
| MIL operation | Immediate |
| Sequence of operation | None |
| The monitor will run whenever this DTC is not present. | P0500 (VSS) P0748, P0778, P0798 (Shift solenoid valve(range)) |
| Engine | Running |
| NSW (STAR) switch | OFF |
| Output shaft rpm | 1000 rpm or more |
| Sensor signal rpm | Less than 300 rpm |
| Counter gear speed sensor (NC) |
|

| READ DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn on the tester.
Select the item "Powertrain / Engine and ECT / Data List".
According to the display on the tester, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| SPD (NC) | Counter Gear Speed/ display: 50 r/min |
| - |
| 1.INSPECT SPEED SENSOR INSTALLATION |
![]() |
Check the speed sensor installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (NC) |
![]() |
Disconnect the speed sensor connector from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR - ECM) |
![]() |
Connect the speed sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B2-34 (NC+) - B2-26 (NC-) | 20°C (68°F) | 560 to 680 Ω |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B2-34 (NC+) - Body ground | Always | 10 kΩ or higher |
| B2-26 (NC-) - Body ground |
|
| ||||
| OK | ||
| ||