DTC P0798 Pressure Control Solenoid "C" Electrical (Shift Solenoid Valve SL3) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0798 |
|
|
| Related DTCs | P0798: Shift solenoid valve SL3/Range check |
| Required sensors/Components | Shift solenoid valve SL3 |
| Frequency of operation | Continuous |
| Duration | 1 sec. |
| MIL operation | Immediate |
| Sequence of operation | None |
| The monitor will run whenever this DTC is not present. | None |
| Battery voltage | 10 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Output signal duty | 100% |
| Output signal duty | Less than 100% |

| 1.INSPECT TRANSMISSION WIRE (SL3) |
![]() |
Disconnect the transmission wire connector from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4 (SL3+) - 11 (SL3-) | 20°C (68°F) | 5.0 to 5.6 Ω |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4 (SL3+) - Body ground | Always | 10 kΩ or higher |
| 11 (SL3-) - Body ground | Always | ↑ |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
![]() |
Connect the transmission wire connector to the transaxle.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B2-17 (SL3+) - B2-16 (SL3-) | 20°C (68°F) | 5.0 to 5.6 Ω |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B2-17 (SL3+) - Body ground | Always | 10 kΩ or higher |
| B2-16 (SL3-) - Body ground |
|
| ||||
| OK | ||
| ||
| 3.INSPECT SHIFT SOLENOID VALVE (SL3) |
![]() |
Remove the shift solenoid valve SL3.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.
|
| ||||
| OK | ||
| ||