Home › TRANSMISSION ยท U151E AUTOMATIC TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE BATTERY


    A171858
  1. Loosen the nut, and disconnect the negative battery terminal.

    CAUTION:
    Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Remove the nut, and separate the positive battery terminal cable.

  1. Loosen the nut, and remove the bolt and battery clamp.

  1. Remove the battery and battery tray.



3. REMOVE COOL AIR INTAKE DUCT SEAL


    A170196
  1. Remove the 11 clips and cool air intake duct seal.



4. REMOVE NO. 2 AIR CLEANER INLET


    A170453
  1. Disconnect the 2 vacuum switching valve clamps.

  1. Disconnect the 2 vacuum hoses.

  1. Remove the 2 bolts and No. 2 air cleaner inlet.



5. REMOVE NO. 1 AIR CLEANER INLET


    A170454
  1. Disconnect the 2 vacuum hoses, and remove the 2 bolts and No. 1 air cleaner inlet.



6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A170887
  1. Disconnect the 3 vacuum hoses.



    A170447
  1. Loosen the No. 1 air cleaner hose clamp.

  1. Disconnect the hose clamps and No. 2 ventilation hose.

  1. Disconnect the mass air flow meter connector.



    A170451
  1. Release the 2 clips, and remove the 2 bolts.

  1. Remove the air cleaner cap sub-assembly and air cleaner filter element.



7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A170450
  1. Remove the 3 bolts, disconnect the hose and the connector, and remove the air cleaner case sub-assembly.



9. REMOVE AIR CLEANER BRACKET


    A171820
  1. Remove the 2 bolts and air cleaner bracket.



10. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    C133984
  1. Remove the nut from the control shaft lever.

  1. Disconnect the control cable from the control shaft lever.



    C167670
  1. Remove the clip and disconnect the control cable from the control cable bracket.

    NOTICE:
    Do not hold the resin guide pipe.



11. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    C173673
  1. Disconnect the park/neutral position switch connector.



    C133985
  1. Remove the nut, washer and control shaft lever.



    C161138
  1. Using a screwdriver, pry up the lock plate.



    G025453
  1. Remove the lock nut and lock plate.



    C099454
  1. Remove the 2 bolts and pull out the park/neutral position switch.