SPEED SENSOR > INSTALLATION |
| 1. INSTALL SPEED SENSOR (NC SENSOR) |
![]() |
Coat a new O-ring with ATF.
Install the speed sensor with the bolt.
Connect the speed sensor connector.
| 2. INSTALL SPEED SENSOR (NT SENSOR) |
![]() |
Coat a new O-ring with ATF.
Install the speed sensor with the bolt.
Connect the speed sensor connector.
| 3. INSTALL AIR CLEANER BRACKET |
![]() |
Install the 2 bolts and air cleaner bracket.
| 4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Install the air cleaner case with the 3 bolts.
Connect the hose and connector.
| 5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| 6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Install the air cleaner filter element, align the groove on the air cleaner hose with the throttle body alignment tab and tighten the clamp as shown in the illustration.
Install the air cleaner cap with the 2 bolts and clips
![]() |
Connect the 3 vacuum hoses.
![]() |
Connect the mass air flow meter connector.
Connect the No. 2 ventilation hose and fuel vapor feed hose assembly.
| 7. INSTALL NO. 1 AIR CLEANER INLET |
![]() |
Install the No. 1 air cleaner inlet with the 2 bolts.
Connect the 2 vacuum hoses.
| 8. INSTALL NO. 2 AIR CLEANER INLET |
![]() |
Install the No. 2 air cleaner inlet with the 2 bolts.
Connect the 2 vacuum hoses and harness clamps.
| 9. INSTALL COOL AIR INTAKE DUCT SEAL |
![]() |
Install the cool air intake duct seal with the 11 clips.
| 10. INSTALL BATTERY |
![]() |
Install the battery tray and battery.
Install the battery clamp with the bolt and nut.
Install the positive battery terminal and nut.
Connect the negative battery terminal, and tighten the nut.
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |