VALVE BODY ASSEMBLY > INSTALLATION |
| 1. INSTALL MANUAL VALVE |
Install the manual valve to the valve body assembly.
| 2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
![]() |
Install the spring and check ball body.
Align the groove of the manual valve with the pin of the lever.
![]() |
Install the 17 bolts.
| 3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
![]() |
Coat a new O-ring with ATF.
Install the O-ring to the oil strainer.
![]() |
Install the oil strainer with the 3 bolts.
| 4. INSTALL TRANSMISSION WIRE |
![]() |
Coat a new O-ring with ATF.
Install the ATF temperature sensor with the lock plate and bolt.
Connect the 7 shift solenoid valve connectors.
| 5. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
![]() |
Install the 2 magnets in the oil pan.
Apply adhesive to the 18 bolts.
![]() |
Install the oil pan and a new gasket to the transaxle case with the 18 bolts.
| 6. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. ADD AUTOMATIC TRANSAXLE FLUID |
| 9. INSPECT AUTOMATIC TRANSAXLE FLUID |
Park the vehicle on a level surface and set the parking brake.
![]() |
With the engine idling and the brake pedal depressed, move the shift lever to all positions from P to S1 and return to the P position.
Take out the dipstick and wipe it clean.
Put the dipstick back all the way.
Take out the dipstick again and check that the fluid level is within the HOT range.
If the fluid level is below the HOT range, add new fluid and recheck the fluid level.
If the fluid level exceeds the HOT range, drain the fluid once, add the proper amount of new fluid and recheck the fluid level.
If there are leaks, it is necessary to repair or replace O-rings, FIPGs, oil seals, plugs and/or other parts.
| 10. INSPECT FOR TRANSAXLE FLUID LEAK |
| 11. INSTALL NO. 2 ENGINE UNDER COVER |
![]() |
Install the No. 2 engine under cover with the 2 bolts.
| 12. INSTALL NO. 1 ENGINE UNDER COVER |
![]() |
Install the No. 1 engine under cover with the 6 bolts and 2 clips.
| 13. INSTALL ENGINE UNDER COVER ASSEMBLY |
![]() |
Install the engine under cover assembly with the 4 bolts and 5 clips.
![]() |
Install the engine under cover assembly RR with the 2 bolts.
| 14. RESET MEMORY |