Home › TRANSMISSION ยท U151E AUTOMATIC TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE ENGINE UNDER COVER ASSEMBLY


    A171849
  1. Remove the 2 bolts and engine under cover assembly RR.



    A171850
  1. Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.



3. REMOVE NO. 1 ENGINE UNDER COVER


    A171855
  1. Remove the 6 bolts, 2 clips and No. 1 engine under cover.



4. REMOVE NO. 2 ENGINE UNDER COVER


    A171854
  1. Remove the 2 bolts and No. 2 engine under cover.



5. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



6. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

HINT:
(Click here)



7. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    C091925
  1. Remove the 18 bolts, oil pan, and gasket.

    NOTICE:
    Some fluid will remain in the oil pan. Carefully remove the oil pan so that the fluid remaining in the pan does not spill out.



    D030865E03
  1. Remove the 2 magnets from the oil pan.



    AT00103
  1. Examine particles in the pan.

    1. Collect any steel chips using the removed magnets. Look carefully at the chips and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle.

      Result:
      Steel (magnetic):
      bearing, gear, or plate wear
      Brass (non-magnetic):
      bushing wear



8. DISCONNECT TRANSMISSION WIRE


    C091927E08
  1. Disconnect the 7 shift solenoid valve connectors.

  1. Remove the bolt and lock plate, and disconnect the ATF temperature sensor.



9. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    C091931
  1. Remove the 3 bolts and oil strainer.

    NOTICE:
    Be careful when removing the oil strainer as fluid will come out.



    C091932
  1. Remove the O-ring from the valve body oil strainer assembly.



10. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    C091933
  1. Support the valve body assembly and remove the 17 bolts and the transmission valve body assembly.



    C050017
  1. Remove the check ball body and the spring.



11. REMOVE MANUAL VALVE
  1. Remove the manual valve from the valve body assembly.