VALVE BODY ASSEMBLY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE UNDER COVER ASSEMBLY |
![]() |
Remove the 2 bolts and engine under cover assembly RR.
![]() |
Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.
| 3. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 6 bolts, 2 clips and No. 1 engine under cover.
| 4. REMOVE NO. 2 ENGINE UNDER COVER |
![]() |
Remove the 2 bolts and No. 2 engine under cover.
| 5. DRAIN AUTOMATIC TRANSAXLE FLUID |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
| 6. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY |
| 7. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
![]() |
Remove the 18 bolts, oil pan, and gasket.
![]() |
Remove the 2 magnets from the oil pan.
![]() |
Examine particles in the pan.
Collect any steel chips using the removed magnets. Look carefully at the chips and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle.
| 8. DISCONNECT TRANSMISSION WIRE |
![]() |
Disconnect the 7 shift solenoid valve connectors.
Remove the bolt and lock plate, and disconnect the ATF temperature sensor.
| 9. REMOVE VALVE BODY OIL STRAINER ASSEMBLY |
![]() |
Remove the 3 bolts and oil strainer.
![]() |
Remove the O-ring from the valve body oil strainer assembly.
| 10. REMOVE TRANSMISSION VALVE BODY ASSEMBLY |
![]() |
Support the valve body assembly and remove the 17 bolts and the transmission valve body assembly.
![]() |
Remove the check ball body and the spring.
| 11. REMOVE MANUAL VALVE |
Remove the manual valve from the valve body assembly.