Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Receiver Communication Error

for Preparation Click here


INSPECTION PROCEDURE

1.IDENTIFY THE COMPONENT SHOWN BY SUB-CODE


  1. Enter the diagnostic mode.


    E110917E05

  1. Press the preset switch "3" to change to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

    HINT:
    1. "P190" set by the radio receiver shown in the preceding illustration as an example.
    2. For details of the DTC display, refer to "DTC CHECK/CLEAR" (Click here).


NEXT


2.CHECK COMPONENT SHOWN BY SUB-CODE
  1. Select the component shown by sub-code.

    HINT:
    The "Bluetooth" handsfree module is built into the radio receiver. If there is a problem between the "Bluetooth" handsfree module and radio receiver, replace the radio receiver.


    Component Table: 
    Component
    Proceed to
    Except "Bluetooth" handsfree module
    A
    "Bluetooth" handsfree module (19D)
    B



B
REPLACE RADIO RECEIVER
A


3.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    If the power source circuit is operating normally, proceed to the next step.

    Component Table: 
    Component
    Proceed to
    Stereo component amplifier (440)
    Stereo component amplifier power source circuit (Click here)
    Television display assembly (1B0)
    Television display assembly power source circuit (Click here)


NEXT


4.INSPECT RADIO RECEIVER


    E151918E11
  1. Disconnect the radio receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E2-5 (ATX+) - E2-15 (ATX-)
    Always
    60 to 80 Ω
    E16-9 (TXM+) - E16-10 (TXM-) (*1)
    Always
    60 to 80 Ω

    HINT:
    *1: w/ Rear Seat Entertainment System



NG
REPLACE RADIO RECEIVER
OK


5.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.

    1. Disconnect all connectors between the radio receiver and the component shown by the sub-code.



    2. Check for an open or short in the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.

      OK:
      There is no open or short circuit.


      E175061E01



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE RADIO RECEIVER
OK

END