Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

ENGINE IMMOBILISER SYSTEM (w/o Smart Key System) > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the transponder key ECU assembly.

WIRING DIAGRAM


B171367E01


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID (Click here).

1.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY)


    B164266E10
  1. Disconnect the transponder key ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D41-1 (+B) - Body ground
    Always
    11 to 14 V
    D41-2 (IG) - Body ground
    Ignition switch OFF
    Below 1 V
    D41-2 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BODY GROUND)


    B164266E11
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D41-16 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)