Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

ENGINE IMMOBILISER SYSTEM (w/o Smart Key System) > Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

When an additional transponder key is registered, the transponder key ECU assembly detects the front door courtesy light switch open/closed condition, and enters the key registration mode.

WIRING DIAGRAM


B171320E02


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID (Click here).

1.CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH CIRCUIT)


    B164266E09
  1. Disconnect the transponder key ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D41-7 (CTY) - Body ground
    Courtesy switch pushed
    (Door closed)
    10 kΩ or higher
    D41-7 (CTY) - Body ground
    Courtesy switch free
    (Door open)
    Below 1 Ω



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)  

2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY


    B111600E08
  1. Remove the driver side front door courtesy light switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Switch body
    Courtesy switch pushed
    (Door closed)
    10 kΩ or higher
    1 - Switch body
    Courtesy switch free
    (Door open)
    Below 1 Ω



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (TRANSPONDER KEY ECU - FRONT DOOR COURTESY LIGHT SWITCH)