Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2780    Push Switch / Key Unlock Warning Switch Malfunction

for Preparation Click here


DESCRIPTION

This DTC will be output if the transponder key ECU assembly does not detect that the unlock warning switch is on even when the ignition switch is in the ON position. Under normal conditions, the unlock warning switch is on when the ignition switch is in the ON position.

DTC No.
DTC Detection Condition
Trouble Area
B2780
"Unlock warning switch ON" is not detected when ignition switch is ON
  1. Wire harness or connector
  2. Unlock warning switch assembly
  3. Transponder key ECU assembly

WIRING DIAGRAM


B151009E06


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID (Click here).

1.READ VALUE ON TECHSTREAM (UNLOCK WARNING SWITCH)
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the tester on.

  1. Select the following menu items: Body Electrical / Immobiliser / Data List.

  1. Select Key SW in the Data List and read the tester display.

    Immobiliser (Transponder Key ECU): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key SW
    Unlock warning switch signal/ON or OFF
    ON: Key is in ignition key cylinder
    OFF: No key is in ignition key cylinder
    -

    OK:
    ON (Key is in ignition key cylinder) appears on the screen.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)  

2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    B164411E01
  1. Remove the unlock warning switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    1 - 2
    Switch pushed
    (Key inserted)
    Below 1 Ω
    1 - 2
    Switch free
    (Key removed)
    10 kΩ or higher



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND)


    B151010E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D19-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - UNLOCK WARNING SWITCH)


    B151011E03
  1. Disconnect the transponder key ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D41-3 (KSW) - D19-1
    Always
    Below 1 Ω
    D19-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)