Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

ENGINE IMMOBILISER SYSTEM (w/o Smart Key System) > Security Indicator Light Circuit

for Preparation Click here


DESCRIPTION

When the transponder key is registered, the transponder key ECU assembly outputs the key registration condition by lighting up, blinking or turning off the security indicator light.

WIRING DIAGRAM


B178835E05


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID (Click here).

1.PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY INDICATOR LIGHT)
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the tester on.

  1. Select the following menu items: Body Electrical / Immobiliser / Active Test.

  1. Perform the Active Test according to the display on the tester.

    Immobiliser: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indic
    Security indicator light
    ON/OFF
    -

    OK:
    The security indicator light turns on and off according to the tester operation.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - SECURITY INDICATOR LIGHT)


    B164264E04
  1. Disconnect the transponder key ECU and security indicator light connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D41-8 (IND) - E19-2 (IND+)
    Always
    Below 1 Ω
    D41-8 (IND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - BODY GROUND)


    B164265E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E19-5 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SECURITY INDICATOR LIGHT (Click here)