Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB (for 2WD)

REAR AXLE HUB (for 2WD) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE REAR WHEEL


3. SEPARATE REAR FLEXIBLE HOSE


    C167792
  1. Remove the bolt and separate the rear flexible hose from the rear shock absorber with coil spring.



4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    C167785
  1. Remove the 2 bolts and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.



5. REMOVE REAR DISC


    C166438E01
  1. Put matchmarks on the rear disc and the axle hub.



    D028126
  1. Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.



6. SEPARATE REAR SPEED SENSOR WIRE


    C167422
  1. Using a screwdriver, disconnect the connector from the rear speed sensor.

    NOTICE:
    Be careful not to damage the rear speed sensor.



7. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    C167786
  1. Remove the 4 bolts and the rear axle hub and bearing assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the parking brake assembly from hanging down by the parking brake cable assembly.



8. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    C165998
  1. Remove the bolt and the nut, and separate the No. 3 parking brake cable assembly.



9. REMOVE REAR STRUT ROD ASSEMBLY


    C167803
  1. Remove the 2 bolts, the 2 nuts, and the rear strut rod assembly.

    NOTICE:
    Since stopper nuts are used, loosen the bolts.



10. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY


    C167788
  1. Loosen the 2 bolts.

    NOTICE:
    Since stopper nuts are used, loosen the bolts.



    C167787
  1. Remove the 2 bolts and 2 nuts, and separate the rear axle carrier sub-assembly from the rear shock absorber with coil spring.



    C167789
  1. Remove the 2 bolts, the 2 nuts, and the rear axle carrier sub-assembly.