DTC B2313 Glass Position Initialization Incomplete |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2313 |
|
|
| 1.CHECK DTC OUTPUT |
Turn the ignition switch off.
Wait for at least 10 seconds, and then turn the ignition switch on (IG).
Check whether the DTC output recurs.
| Result | Proceed to |
| B213 is not output | A |
| B2313 is output | B |
|
| ||||
| B | |
| 2.INITIALIZE SYSTEM (POWER WINDOW CONTROL SYSTEM) |
Turn the ignition switch on (IG) and initialize the power window regulator motor (on the driver side) (Click here).
Turn the ignition switch off.
Wait for at least 10 seconds, and then turn the ignition switch on (IG).
Check whether the DTC output recurs.
| Result | Proceed to |
| B2313 is output | A |
| B213 is not output | B |
|
| ||||
| A | ||
| ||