Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System)

DTC    B1242    Wireless Door Lock Tuner Circuit Malfunction

for Preparation Click here


DESCRIPTION

The door control receiver receives signals from the transmitter and sends these signals to the main body ECU.

DTC No.
DTC Detection Condition
Trouble Area
B1242
In diagnostic mode, an applicable RDA signal cannot be received within 1 second after an PRG signal has been output from the main body ECU.
  1. Wire harness or connector
  2. Door control receiver
  3. Main body ECU

WIRING DIAGRAM


B176380E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - DOOR CONTROL RECEIVER)


  1. Disconnect the D7 main body ECU connector and the O32 door control receiver connector.


    B175272E03

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      D7-12 (RDA) - O32-2 (RDA)
      Always
      Below 1 Ω
      D7-12 (RDA) - Body ground
      Always
      10 kΩ or higher
      D7-10 (PRG) - O32-3 (PRG)
      Always
      Below 1 Ω
      D7-10 (PRG) - Body ground
      Always
      10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (BATTERY, BODY GROUND)


    B175276E03
  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    O32-1 (GND) - Body ground
    Always
    Below 1 Ω
    O32-5 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE DOOR CONTROL RECEIVER
  1. Reconnect the E6 main body ECU connector.

  1. Replace the door control receiver with a normal one (Click here).

  1. Perform the registration procedures (Click here).

    HINT:
    If a normally functioning door control receiver is available, connect it and check if the wireless door lock function is normal or DTCs are output. If the alternative receiver functions normally, replace the original door control receiver.


NEXT


4.CONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check if the same DTC is detected.

    HINT:
    Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.

    Result:
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)