Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

DTC    B1625/22    Front Passenger Side - Side Airbag Sensor Malfunction

for Preparation Click here


DESCRIPTION

The side airbag sensor RH circuit consists of the center airbag sensor assembly, side airbag sensor RH and rear airbag sensor RH.
The side airbag sensor RH and rear airbag sensor RH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbag should be deployed.
DTC B1625/22 is recorded when a malfunction is detected in the side airbag sensor RH.

DTC No.
DTC Detection Condition
Trouble Area
B1625/22
  1. Side airbag sensor RH malfunction
  2. Center airbag sensor assembly malfunction
  1. Side airbag sensor RH
  2. Center airbag sensor assembly

WIRING DIAGRAM


C165789E05


INSPECTION PROCEDURE

1.CHECK SIDE AIRBAG SENSOR RH


    C167955E01
  1. Turn the ignition switch off.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Interchange the side airbag sensor RH with LH and connect the connectors to them.

  1. Connect the negative (-) terminal cable to the battery.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Clear the DTCs stored in the memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC B1620/21 and B1625/22 are not output.
    A
    DTC B1625/22 is output.
    B
    DTC B1620/21 is output.
    C

    HINT:
    Codes other than DTC B1620/21 and B1625/22 may be output at this time, but they are not related to this check.



B
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)

C
REPLACE SIDE AIRBAG SENSOR RH (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)