Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

DTC    B1630/23    Driver Side Rear Airbag Sensor Malfunction

for Preparation Click here


DESCRIPTION

The rear airbag sensor LH circuit consists of the center airbag sensor assembly, rear airbag sensor LH, and side airbag sensor LH.
The side airbag sensor LH and rear airbag sensor LH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbag should be deployed.
DTC B1630/23 is recorded when a malfunction is detected in the rear airbag sensor LH.

DTC No.
DTC Detection Condition
Trouble Area
B1630/23
  1. Rear airbag sensor LH malfunction
  2. Center airbag sensor assembly malfunction
  1. Rear airbag sensor LH
  2. Center airbag sensor assembly

WIRING DIAGRAM


C165789E04


INSPECTION PROCEDURE

1.CHECK REAR AIRBAG SENSOR LH


    C114844E05
  1. Turn the ignition switch off.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Interchange the rear airbag sensor LH with RH and connect the connectors to them.

  1. Connect the negative (-) terminal cable to the battery.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Clear the DTCs stored in the memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC B1630/23 and B1635/24 are not output
    A
    DTC B1630/23 is output
    B
    DTC B1635/24 is output
    C

    HINT:
    Codes other than DTC B1630/23 and B1635/24 may be output at this time, but they are not related to this check.



B
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)

C
REPLACE REAR AIRBAG SENSOR LH (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)