Home › ENGINE › 2GR-FE CHARGING › CHARGING SYSTEM

CHARGING SYSTEM > PRECAUTION

for Preparation Click here



1.PRECAUTION FOR DISCONNECTING THE BATTERY CABLE

NOTICE:
When disconnecting the battery negative (-) terminal, initialize the following systems after the terminal is reconnected:
System Name
See Procedure
Power Back Door System
Click here


2.IGNITION SWITCH EXPRESSIONS

HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression
Ignition Switch (position)
Engine Switch (condition)
Ignition Switch off
LOCK
Off
Ignition Switch on (IG)
ON
On (IG)
Ignition Switch on (ACC)
ACC
On (ACC)
Engine Start
START
Start


3.Check that the battery cables are connected to the correct terminals.

4.Disconnect the battery cables when the battery is given a quick charge.

5.Do not perform tests with a high voltage insulation resistance tester.

6.Never disconnect the battery cables while the engine is running.

7.Check that the charging cable nut is tightened on terminal B of the generator and the engine room relay block.