Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Meter Illumination is Always Dark

for Preparation Click here


DESCRIPTION

In this circuit, the meter CPU receives auto dimmer signals from the main body ECU using the CAN communication lines (CAN MS Bus). When the meter CPU receives an auto dimmer signal, it dims the meter illumination. The main body ECU determines whether it is daytime, twilight, or nighttime based on the waveform transmitted from the automatic light control sensor. If the main body ECU determines that it is daytime, the ECU does not send auto dimmer signals. Therefore, the meter illumination (warning and indicator lights) will not dim even if the driver accidentally turns the light control switch to the TAIL or HEAD position in daytime.

HINT:
When the meter illumination is always dark, or the meter illumination does not dim at night, there may be a malfunction in automatic light control sensor, main body ECU, CAN communication system, wire harness or connector, or combination meter assembly.


WIRING DIAGRAM


for Manual A/C:

E146931E04


for Automatic A/C:

E146931E05


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication DTC is output (Click here).

    Result:

    Result
    Proceed to
    CAN communication DTC is not output.
    A
    CAN communication DTC is output.
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK DTC
  1. Check if DTC B1244 is output (Click here).


Result:

Result
Proceed to
B1244 is not output.
A
B1244 is output.
B



B
GO TO LIGHTING SYSTEM (Click here)
A


3.READ VALUE USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Ignition switch on (IG).

  1. Turn the tester on.

  1. Turn the light control rheostat to the TAIL/HEAD position.

  1. Enter the following menus: Body Electrical / Main Body / Data List.

  1. Check the meter illumination.

    Main Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Illumination Rate Info
    Illumination rate information / 0 ms. to 99.99 ms.
    0.8 to 22.0 ms (Value is output according to outside illuminance)
    -

    OK:
    Normal condition listed above is displayed.

    HINT:
    Meter illumination is adjusted by automatic light control system and controlled according to the outside light. The automatic light control sensor sensitiveness can be customized. Therefore, when the Data List value is normal, confirm the sensitivity setting in the customization table of the automatic light control system.



NG
Go to step 4
OK

CHECK LIGHTING SETTING (Click here)  

4.REPLACE COMBINATION METER ASSEMBLY
  1. Replace the combination meter assembly with a new or a normal one .

    OK:
    The operation of the combination meter assembly returns to normal.



NG
REPLACE MAIN BODY ECU
OK

END