Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/ Navigation System)

REAR VIEW MONITOR SYSTEM (w/ Navigation System) > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch.

WIRING DIAGRAM


E150789E01


INSPECTION PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E141022E07
  1. Disconnect navigation receiver assembly connector E5.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E5-5 (REV) - Body ground
    Ignition switch on (IG)
    Shift lever R position
    10 to 14 V
    E5-5 (REV) - Body ground
    Ignition switch on (IG)
    Shift lever any position except R
    Below 1 V



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)


    E150782E05
  1. Disconnect navigation receiver assembly connector E5 and park/neutral position switch connector B5.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E5-5 (REV) - B5-1 (RL)
    Always
    Below 1 Ω
    E5-5 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT PARK/NEUTRAL POSITION SWITCH


    E153722E01
  1. Disconnect park/neutral position switch connector B5.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B5-1 (RL) - B5-2 (RB)
    Shift lever R position
    Below 1 Ω
    B5-1 (RL) - B5-2 (RB)
    Shift lever any position except R
    10 kΩ or higher

    Result:
    Result
    Proceed to
    OK
    A
    NG (for U151E)
    B
    NG (for U151F)
    C



B
REPLACE PARK/NEUTRAL POSITION SWITCH (for U151E) (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH (for U151F) (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR