POWER DOOR LOCK CONTROL SYSTEM > Only Back Door LOCK / UNLOCK Functions do not Operate |

| 1.SYSTEM CHECK |
Check if the vehicle is equipped with a back door closer system.
| Result | Proceed to |
| w/ Back Door Closer System | A |
| w/o Back Door Closer System | B |
|
| ||||
| B | |
| 2.READ VALUE USING TECHSTREAM |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Enter the following menus:
Body Electrical / Main Body / Data List.
Select Back Door Open Handle in the Data List and read the tester display.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Back Door Open Handle | Back door opener switch/ON or OFF | ON: Back door opener switch is pushed OFF: Back door opener switch is not pushed | - |
|
| ||||
| OK | |
| 3.INSPECT BACK DOOR LOCK ASSEMBLY |
![]() |
Remove the back door lock assembly (Click here).
Check operation of the door lock motor.
Move the door lock to the lock position.
Apply battery voltage to the door lock motor and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 2 Battery negative (-) → Terminal 1 | Unlocked |
Check operation of the door courtesy switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 3 | Locked | 10 kΩ or higher |
| 1 - 3 | Unlocked | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK CIRCUIT) |
![]() |
Disconnect the main body ECU (instrument panel junction block) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T3-2 (ACT+) - D7-1 (TR+) | Always | Below 1 Ω |
| T3-2 (ACT+) - Body ground | Always | 10 kΩ or higher |
| T3-3 (D+) - D7-25 (BCTY) | Always | Below 1 Ω |
| T3-3 (D+) - Body ground | Always | 10 kΩ or higher |
| T3-1 (ACT-) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 5.INSPECT BACK DOOR OPENER SWITCH |
Remove the back door opener switch (Click here).

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 2 - 3 | Back door opener switch not pushed (OFF) | 10 kΩ or higher |
| 2 - 3 | Back door opener switch pushed (ON) | Below 1 Ω |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (BACK DOOR OPENER SWITCH CIRCUIT) |
![]() |
Disconnect the main body ECU (instrument panel junction block) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| h1-3 (B) - D8-26 (BDSU) | Always | Below 1 Ω |
| h1-3 (B) - Body ground | Always | 10 kΩ or higher |
| h1-2 (L) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||