Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CRUISE CONTROL MAIN SWITCH
  1. Remove the cruise control main switch (Click here).



  1. Measure the resistance according to the value(s) in the table below.


    E106137E31


    Standard resistance:

    Tester Connection
    Switch Condition
    Specified Condition
    A-1 (ECC) - A-3 (CCS)
    Main Switch off*1
    1 MΩ or higher
    Main Switch on
    Below 2.5 Ω
    + RES
    235 to 245 Ω
    - SET
    617 to 643 Ω
    CANCEL
    1509 to 1571 Ω

    *1: Lever is in the neutral position
    If the result is not as specified, replace the cruise control main switch.