CRUISE CONTROL MAIN SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Disengage the claw and remove the lower No. 3 steering wheel cover.
| 3. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Disengage the claw and remove the lower No. 2 steering wheel cover.
| 4. REMOVE STEERING PAD |
![]() |
Using a "TORX" socket wrench (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
![]() |
Disconnect the horn connector from the steering pad.
Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors and remove the steering pad.
| 5. REMOVE CRUISE CONTROL MAIN SWITCH |
![]() |
Remove the 2 screws.
Disconnect the connector.
![]() |
Remove the cruise control main switch as shown in the illustration.