Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch and information about the GPS antenna, and then adjusts the vehicle position on the navigation display.

WIRING DIAGRAM


E150789E01


INSPECTION PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E141022E05
  1. Disconnect navigation receiver assembly connector E5.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E5-5 (REV) - Body ground
    Ignition switch on (IG)
    Shift lever R position
    11 to 14 V
    E5-5 (REV) - Body ground
    Ignition switch on (IG)
    Shift lever any position except R
    Below 1 V



NG
Go to step 2
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)


    E150782E03
  1. Disconnect navigation receiver assembly connector E5.

  1. Disconnect park/neutral position switch connector B5.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E5-5 (REV) - B5-1 (RL)
    Always
    Below 1 Ω
    E5-5 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - BATTERY)


    E150783E03
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    B5-2 (RB) - Body ground
    Ignition switch on (IG)
    11 to 14 V

    Result:
    Result
    Proceed to
    NG
    A
    OK (for U151E)
    B
    OK (for U151F)
    C



B
REPLACE PARK/NEUTRAL POSITION SWITCH (for U151E) (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH (for U151F) (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR