ENGINE SWITCH > INSTALLATION |
| 1. INSTALL ENGINE SWITCH |
![]() |
Engage the 2 claws to install the switch.
Connect the switch connector.
| 2. INSTALL FRONT NO. 1 CONSOLE BOX INSERT |
![]() |
Engage the claw and 2 guides.
Install the front No. 1 console box insert with the 3 screws <F> and 2 clips.
| 3. INSTALL CONSOLE BOX ASSEMBLY (w/o Rear Air Conditioning System) |
![]() |
Engage the 6 claws.
![]() |
Install the console box assembly with the 4 bolts and 2 screws.
| 4. INSTALL CONSOLE BOX ASSEMBLY (w/ Rear Air Conditioning System) |
![]() |
Engage the 6 claws.
Connect the connector.
![]() |
Install the console box assembly with the 4 bolts and 2 screws.
| 5. INSTALL LOWER REAR CONSOLE BOX |
Install the lower rear console box.
| 6. INSTALL NO. 2 CONSOLE BOX DUCT (w/o Rear Air Conditioning System) |
![]() |
Install the No. 2 console box duct as shown in the illustration.
| 7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Connect the connector.
Engage the 4 claws and 4 clips, and install the upper console panel sub-assembly.
| 8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System) |
![]() |
Connect the hood lock control cable assembly.
Connect each connector and the aspirator duct.
![]() |
Engage the 3 claws and 10 clips.
Install the lower instrument panel finish panel sub-assembly with the 2 bolts <B>.
| 9. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System) |
![]() |
Connect the hood lock control cable assembly.
Connect each connector.
Engage the 3 claws and 10 clips.
Install the lower instrument panel finish panel sub-assembly with the 2 bolts <B>.
| 10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH |
![]() |
Engage the claw and clip, install the cowl side trim sub-assembly LH.
Install the clip.
| 11. INSTALL FRONT DOOR SCUFF PLATE LH |
![]() |
Engage the guide and the 8 claws, and install the front door scuff plate LH.
| 12. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System) |
Connect the connector.
![]() |
Engage the 4 clips and install the air conditioning control assembly.
| 13. INSTALL HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System) |
Connect the connector.
![]() |
Engage the 4 clips and install the heater control and accessory assembly.
| 14. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Key System) |
![]() |
Apply protective tape to the areas shown in the illustration.
Connect each connector.
Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.
| 15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |