DTC C1551 IG Power Supply Voltage Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1551 | IG power source circuit malfunction inside ECU |
|

| 1.READ VALUE USING TECHSTREAM (IG POWER SUPPLY) |
Turn the ignition switch off.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn Techstream on.
Enter the following menus: Chassis / EMPS / Data List.
Select the item "IG Power Supply" in the Data List and read the value displayed on Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG Power Supply | IG power supply: Min.: 0 V Max.: 20.1531 V | 11 to 14 V | Ignition switch on (IG) |
|
| ||||
| OK | ||
| ||
| 2.INSPECT FUSE (ECU IG NO. 1) |
Remove the ECU IG NO. 1 fuse from the instrument panel junction block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY) |
![]() |
Disconnect the connectors from the power steering ECU.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D6-5 (IG) - Body ground | Ignition switch on (IG) | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D5-2 (PGND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||