Home › STEERING › POWER STEERING › POWER STEERING SYSTEM

DTC    C1552    PIG Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

When a problem occurs in the power steering system, the power source relay circuit is shut off to stop the power assist.

DTC No.
DTC Detection Condition
Trouble Area
C1552
PIG power source circuit malfunction inside ECU
  1. PIG power source circuit
  2. Power steering ECU

WIRING DIAGRAM


C160852E06


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (PIG POWER SUPPLY)
  1. Turn the ignition switch off.

  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn Techstream on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item "PIG Power Supply" in the Data List and read the value displayed on Techstream.

    EMPS: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    PIG Power Supply
    PIG power supply:
    Min.: 0 V
    Max.: 20.1531 V
    11 to 14 V
    Power steering is in operation

OK:
The normal condition value is displayed on the Techstream display.



NG
Go to step 2
OK

CHECK INTERMITTENT PROBLEMS 

2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND)


    C113534E10
  1. Disconnect the connector from the power steering ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D5-1 (PIG) - Body ground
    Ignition switch on (IG)
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D5-2 (PGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU (Click here)