Home › STEERING › POWER STEERING › POWER STEERING SYSTEM

DTC    U0073    Control Module Communication Bus OFF

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0129    Lost Communication with Brake System Control Module

for Preparation Click here


DESCRIPTION

The power steering ECU receives signals from the ECM and the skid control ECU via the CAN communication system.

DTC No.
DTC Detection Condition
Trouble Area
U0073
Control module communication bus off
CAN communication system
U0100
Lost communication with ECM/PCM "A"
  1. CAN communication system
  2. ECM
U0129
Lost communication with brake system control module
  1. CAN communication system
  2. Skid control ECU

HINT:
  1. When 2 or more DTCs starting with [U] are output simultaneously, inspect the connectors and wire harness of each ECU.
  2. If DTC U0100 is output, first erase the DTCs. Then turn the ignition switch from off to on (IG). If DTC U0100 is not output again, there is no malfunction.


WIRING DIAGRAM


C170031E04


INSPECTION PROCEDURE

1.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK

CHECK INTERMITTENT PROBLEMS