Home › STEERING › POWER STEERING › POWER STEERING SYSTEM

DTC    C1581    Assist Map Number Un-Writing

for Preparation Click here


DESCRIPTION

The power steering ECU outputs this DTC when it determines that the assist map is not written in the ECU.

HINT:
The assist map data is written in the power steering ECU to control assisting power.
The assist map has 3 types. Select an assist map according to the vehicle country information that is recorded in the ECU.


DTC No.
DTC Detection Condition
Trouble Area
C1581
Assist map not written in power steering ECU
Power steering ECU

INSPECTION PROCEDURE

1.PERFORM ASSIST MAP WRITING
  1. Turn the ignition switch on (IG).

  1. Connect Techstream to the DLC3.

    HINT:
    At this time, check that the P/S warning light is illuminated.

    1. Select the signal check, and change to test mode.

  1. Wait for 3 seconds.


NEXT


2.CHECK P/S WARNING LIGHT
  1. Check the P/S warning light.

    Result:
    Result
    Proceed to
    P/S warning light illuminates
    A
    P/S warning light blinks at 0.25 seconds intervals
    B

    HINT:
    If the P/S warning light blinks at 0.25 seconds intervals, the assist map adjustment has completed normally.



B
END
A


3.CHECK DTC
  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    C1581 is output
    Assist map write adjustment operation not completed 3 times or more
    A
    Code other than C1581 is output
    B
    C1581 is output
    Assist map write adjustment operation not completed less than 3 times
    C

    HINT:
    If DTC C1581 is output, turn the ignition switch off. Enter the test mode again. If the DTC is output 3 times in a row, replace the power steering ECU.



B
REFER TO CIRCUITS INDICATED BY OUTPUT DTCS (Click here)

C
PERFORM ASSIST MAP WRITING
A

REPLACE POWER STEERING ECU (Click here)