ENGINE > ON-VEHICLE INSPECTION |
| 1. INSPECT ENGINE COOLANT |
Inspect the engine coolant .
| 2. INSPECT ENGINE OIL |
Inspect the engine oil .
| 3. INSPECT BATTERY |
Inspect the battery .
| 4. INSPECT AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
Remove the air cleaner filter element sub-assembly.
Visually check that there is no dirt, blockage, and/or damage to the air cleaner filter element sub-assembly.
| 5. INSPECT SPARK PLUG |
Inspect the spark plugs (Click here).
| 6. INSPECT VALVE LASH ADJUSTER NOISE |
Rev up the engine several times. Check that the engine does not emit unusual noises.
If unusual noises occur, warm up the engine and idle it for over 30 minutes. Then perform the preceding inspection.
| 7. INSPECT IGNITION TIMING |
When using Techstream:
Check the ignition timing.
Connect Techstream to the DLC3.
Warm up the engine.
Turn the tester on.
Enter the following menu items: Powertrain / Engine and ECT / Data List / IGN Advance.
Read the value displayed on the tester.
![]() |
When not using Techstream:
Check the ignition timing.
Warm up the engine.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Remove the V-bank cover sub-assembly.
![]() |
Pull out the red lead wire harness.
Connect the tester terminal of the timing light to the red lead wire as shown in the illustration.
Check the ignition timing at idle.
Disconnect terminals 13 (TC) and 4 (CG) of the DLC3.
Check the ignition timing at idle.
Confirm that the ignition timing advances immediately when the engine rpm is increased.
Remove the timing light from the engine.
| 8. INSPECT ENGINE IDLE SPEED |
When using Techstream:
Check the idle speed.
Connect Techstream to the DLC3.
Warm up the engine.
Turn the tester on.
Enter the following menu items: Powertrain / Engine and ECT / Data List / Engine Speed.
Read the value displayed on the tester.
![]() |
When not using Techstream:
Check the idle speed.
Warm up the engine.
Using SST, connect the tachometer test probe to terminal 9 (TAC) of the DLC3.
Check the idle speed.
| 9. INSPECT COMPRESSION |
Warm up and stop the engine.
Disconnect the injector assembly connectors.
Remove the intake air surge tank assembly .
Remove the 6 ignition coils.
Remove the 6 spark plugs.
![]() |
Check the cylinder compression pressure.
Insert a compression gauge into the spark plug hole.
While cranking the engine, measure the compression pressure.
If the cylinder compression is low, pour a small amount of engine oil into the cylinder through the spark plug hole and inspect again.
Install the 6 spark plugs.
Install the 6 ignition coils.
Install the intake air surge tank assembly .
| 10. INSPECT CO/HC |
Start the engine.
Run the engine at 2500 rpm for approximately 180 seconds.
Insert the CO/HC meter testing probe at least 40 cm (1.3 ft.) into the tailpipe during idling.
Check CO/HC concentration at idle and/or 2500 rpm.
Check the air fuel ratio sensor and heated oxygen sensor operation.
See the following table for possible causes, and then inspect and repair if necessary.
| CO | HC | Problem | Cause |
| Normal | High | Rough idle |
|
| Low | High | Rough idle (Fluctuating HC reading) |
|
| High | High | Rough idle (Black smoke from exhaust) |
|