IGNITION COIL AND SPARK PLUG > ON-VEHICLE INSPECTION |
| 1. INSPECT IGNITION COIL ASSEMBLY |
Check for DTCs.
Remove the ignition coil assembly and spark plug (Click here).
Check that sparks occur.
![]() |
Disconnect the 6 fuel injector connectors.
Install the spark plug to ignition coil, and connect the ignition coil connector.
![]() |
Ground the spark plug.
Check if spark occurs at each spark plug while the engine is being cranked.
Perform the spark test according to the flowchart below:
Check that the ignition coil connector is securely connected.
| Result | Action |
| NG | Connect securely |
| OK | Go to next step |
Perform a spark test on each ignition coil.
| Result | Action |
| NG | Go to next step |
| OK | Replace ignition coil |
Check the spark plug (to INSPECT SPARK PLUG).
| Result | Action |
| NG | Replace spark plug |
| OK | Go to next step |
Check the power supply to the ignition coil.
| Result | Action |
| NG | Check wiring between ignition switch and ignition coil |
| OK | Go to next step |
Measure the resistance of the crankshaft position sensor (Click here).
| Result | Action |
| NG | Replace crankshaft position sensor |
| OK | Go to next step |
Check the IGT signal from the ECM (Click here).
| Result | Proceed to Action |
| NG | Check ECM |
| OK | Repair wiring between ignition coil and ECM |
Using a 16 mm plug wrench, install the spark plugs.
Connect the 6 fuel injector connectors.
Install the ignition coil assembly (Click here).
| 2. INSPECT SPARK PLUG |
![]() |
Check the electrode.
Using a megohmmeter, measure the insulation resistance.
Alternative inspection method:
Quickly accelerate the engine to 4000 rpm 5 times.
Remove the spark plugs.
Visually check the spark plug.
If the electrode is dry, the spark plug is functioning properly. If the electrode is damp, proceed to the next step.
Check the spark plug for any damage to its threads and insulator. If there is damage, replace the spark plug.
| Manufacturer | Spark Plug Type |
| DENSO | FK20HR11 |
![]() |
Check the spark plug electrode gap.
![]() |
Clean the spark plugs.
Install the ignition coil assembly and spark plug. (Click here).