DTC P0125 Insufficient Coolant Temperature for Closed Loop Fuel Control |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0125 | Engine coolant temperature does not reach closed-loop enabling temperature for 20 minutes (this period varies with engine start engine coolant temperature) |
|
| Related DTCs | P0125: Insufficient engine coolant temperature for closed-loop fuel control |
| Required Sensors / Components (Main) | Thermostat, cooling system |
| Required Sensors / Components (Related) | Engine coolant temperature sensor and mass air flow meter |
| Frequency of Operation | Continuous |
| Duration | 71 seconds: Engine coolant temperature at engine start -8.33°C (17°F) or more 126 seconds: Engine coolant temperature at engine start -19.44 to -8.33°C (-3 to 17°F) 20 minutes: Engine coolant temperature at engine start less than -19.44°C (-3°F) |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | None |
| Thermostat (P0128) | OK |
| Mass air flow meter (P0100, P0101, P0102, P0103) | OK |
| Intake air temperature sensor (P0110, P0112) | OK |
| Engine coolant temperature sensor (P0115, P0117, P0118) | OK |
| Time until actual engine coolant temperature reaches closed-loop fuel control enabling temperature | 71 seconds or more: Engine coolant temperature at engine start -8.33°C (17°F) or more 126 seconds or more: Engine coolant temperature at engine start -19.44 to -8.33°C (-3 to 17°F) 20 minutes or more: Engine coolant temperature at engine start less than -19.44°C (-3°F) |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0125) |
Connect the Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Trouble Code.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0125 | A |
| P0125 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT THERMOSTAT |
Remove the thermostat (Click here).
Check the valve opening temperature of the thermostat.
Reinstall the thermostat (Click here).
|
| ||||
| OK | |
| 3.CHECK COOLING SYSTEM |
Check for defects in the cooling system that might cause the system to be too cold, such as abnormal radiator fan operation or any modifications.
|
| ||||
| OK | ||
| ||