DTC P2111 Throttle Actuator Control System - Stuck Open |
DTC P2112 Throttle Actuator Control System - Stuck Closed |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2111 | ECM signals throttle actuator to close, but stuck (1 trip detection logic) |
|
| P2112 | ECM signals throttle actuator to open, but stuck (1 trip detection logic) |
|
| Related DTCs | P2111: Throttle actuator stuck open P2112: Throttle actuator stuck closed |
| Required Sensors / Components (Main) | Throttle actuator |
| Required Sensors / Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 0.5 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | None |
| All of the following conditions are met | - |
| System guard* | ON |
| Throttle actuator current | 2 A or more |
| Throttle actuator close duty ratio | 80% or more |
| All of the following conditions are met | - |
| System guard* | ON |
| Throttle actuator current | 2 A or more |
| Throttle actuator open duty-cycle | 80% or more |
| Throttle actuator | ON |
| Throttle actuator duty calculation | Executing |
| Throttle position sensor | Fail determined |
| Throttle actuator current-cut operation | Not executing |
| Throttle actuator power supply | 4 V or more |
| Throttle actuator | Fail determined |
| Throttle position sensor voltage change | No change |
| Throttle position sensor voltage change | No change |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2111 OR P2112) |
Connect the Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P2111 or P2112 | A |
| P2111 or P2112 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT THROTTLE BODY (VISUALLY CHECK THROTTLE VALVE) |
Check for contamination between the throttle valve and the housing. If necessary, clean the throttle body. And check that the throttle valve moves smoothly.
|
| ||||
| OK | |
| 3.CHECK WHETHER DTC OUTPUT RECURS (DTC P2111 OR P2112) |
Connect the Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Clear the DTCs (Click here).
Start the engine, and fully depress and release the accelerator pedal quickly (to fully open and close the throttle valve).
Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| No DTC | A |
| P2111 or P2112 | B |
|
| ||||
| A | ||
| ||