Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P2610    ECM / PCM Internal Engine Off Timer Performance

for Preparation Click here


DTC SUMMARY


DTCs
Monitoring Item
Malfunction Detection Condition
Trouble Area
Detection Timing
Detection Logic
P2610
Soak timer (built into ECM)
ECM internal malfunction
ECM
Engine running
2 trip

DESCRIPTION

To ensure the accuracy of the EVAP (Evaporative Emission) monitor values, the soak timer, which is built into the ECM, measures 5 hours (+/- 15 minutes) from when the ignition switch is turned off, before the monitor is run. This allows the fuel to cool down, which stabilizes the Fuel Tank Pressure (FTP). When 5 hours have elapsed, the ECM turns on.

A172776E01


MONITOR DESCRIPTION

5 hours after the ignition switch is turned off, the soak timer activates the ECM to begin the EVAP system monitor. While the engine is running, the ECM monitors the synchronization of the soak timer and the CPU clock. If these two are not synchronized, the ECM interprets this as a malfunction, illuminates the MIL and sets the DTC (2 trip detection logic).

MONITOR STRATEGY


Required Sensors / Components
ECM
Frequency of Operation
Once per driving cycle
Duration
10 minutes
MIL Operation
2 driving cycles
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


Case 1: 
The monitor will run whenever these DTCs are not present
None
Ignition switch
ON (IG)
Engine
Running
Battery voltage
8 V or more
Starter
OFF

Case 2: 
Internal engine OFF timer (elapsed time from engine stop)
10 to 30 minutes
Battery voltage
8 V or more
Ignition switch
ON (IG)
Starter
OFF

Case 3: 
Internal engine OFF timer (elapsed time from engine stop)
40 minutes
Battery voltage
8 V or more
Ignition switch
ON (IG)
Starter
OFF

TYPICAL MALFUNCTION THRESHOLDS


Case 1: 
Soak timer measurement when ECM CPU clock counts 10 minutes
Less than 7 minutes or more than 13 minutes

Case 2: 
ECM had the started record by internal engine
Yes

Case 3: 
ECM had the started record by internal engine
No

INSPECTION PROCEDURE

HINT:
  1. DTC P2610 is set if an internal ECM problem is detected. Diagnostic procedures are not required. ECM replacement is required.
  2. Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

1.REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


2.CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Clear the DTCs (Click here).

  1. Start the engine and wait for 10 minutes or more.

  1. Select the following menu items: Powertrain / Engine and ECT / Trouble Codes / Pending.

  1. If no pending DTC is displayed, the repair has been successfully completed.

    OK:
    No DTC output.



NG
CHECK FOR INTERMITTENT PROBLEMS (Click here)
OK

END