Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > Air Intake Control Circuit

for Preparation Click here


DESCRIPTION

The air cleaner is equipped with two inlets, one of which is opened or closed by the Air Intake Control Valve (AICV). This system reduces intake noise and increases engine power at low-to-high engine speed range.
When the engine is operating in the low-to-mid speed range, this control operates the AICV to close one of the air cleaner inlets. When the engine speed is more than 3600 rpm and the opening angle of the throttle valve is more than 60°, the ECM activates the VSV and opens the AICV.

A061332E06


WIRING DIAGRAM


A136867E24


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (ACTIVATE THE VSV FOR AICS)


    A067588E07
  1. Disconnect the 2 hoses from the VSV for air intake control valve.

  1. Turn the ignition switch on (IG) and turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / Active Test / Activate the VSV for AICS.

  1. Check the operation of the VSV when the VSV is operated by the tester.

    Standard:
    Tester Operation
    Specified Condition
    VSV is ON
    Air from port E flows out through port F
    VSV is OFF
    Air from port E flows out through the air filter



NG
Go to step 3
OK


2.INSPECT VACUUM TANK
  1. Inspect the vacuum tank (Click here).



NG
REPAIR OR REPLACE AIR CLEANER CAP
OK

CHECK ECM POWER SOURCE CIRCUIT (Click here)  

3.CHECK VSV (FOR AICV)
  1. Inspect the VSV for AICV (Click here).



NG
REPLACE VSV (FOR AICV) (Click here)
OK


4.INSPECT TERMINAL VOLTAGE (VSV FOR AIR INTAKE CONTROL VALVE CONNECTOR)


    A168222E01
  1. Disconnect the VSV for air intake control valve connector.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Ignition switch on (IG)
    9 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (EFI NO. 3 FUSE - VSV FOR AIR INTAKE CONTROL VALVE)
OK


5.CHECK HARNESS AND CONNECTOR (VSV FOR AIR INTAKE CONTROL VALVE - ECM)


    A168217E02
  1. Disconnect the VSV for air intake control valve connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Check for open:
    Tester Connection
    Condition
    Specified Condition
    A10-2 (VSV for AICV) - B1-27 (AICV)
    Always
    Below 1 Ω
    Check for short:
    Tester Connection
    Condition
    Specified Condition
    A10-2 (VSV for AICV) or B1-27 (AICV) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (VSV FOR AICV - ECM)
OK

REPLACE ECM (Click here)