Home › BODY › ENGINE HOOD / DOOR › POWER BACK DOOR SYSTEM

POWER BACK DOOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the power back door system.
  2. *: Use Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use Techstream to check if the CAN communication system is functioning normally.

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    Go to CAN COMMUNICATION SYSTEM
    A


    4.CHECK FOR DTC*
    1. Check for DTCs (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs (Click here).

      Result:
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    Go to DIAGNOSTIC TROUBLE CODE CHART
    A


    5.PROBLEM SYMPTOMS TABLE

      Result:

      Result
      Proceed to
      Fault is not listed on problem symptoms table
      A
      Fault is listed on problem symptoms table
      B



    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation check (Click here)

    2. Terminals of ECU (Click here)

    3. Data List / Active Test (Click here)


    NEXT


    7.REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END