Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    B1422/22    Compressor Lock Sensor Circuit

for Preparation Click here


SYSTEM DESCRIPTION

The ECM sends the engine speed signal to the air conditioning amplifier via CAN communication.
The air conditioning amplifier reads the difference between compressor speed and engine speed. When the difference becomes too large, the air conditioning amplifier determines that the compressor is locked, and turns the magnetic clutch off.

DTC No.
DTC Detection Condition
Trouble Area
B1422/22
Open or short in compressor lock sensor circuit
  1. Air conditioning compressor (Air conditioning lock sensor)
  2. Compressor drive belt
  3. Harness or connector between compressor and air conditioning amplifier
  4. Air conditioning amplifier
  5. CAN communication system

WIRING DIAGRAM


E154278E02


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Use Techstream to check if the CAN communication system is functioning normally.

    OK:
    CAN DTC is not output



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.INSPECT AIR CONDITIONING AMPLIFIER


    E124471E38
  1. Remove the air conditioning amplifier with the connectors still connected.



    E116941E03
  1. Measure the waveform of the connector.
    Item
    Contents
    Tool setting
    200 mV/DIV., 10 ms./DIV.
    Vehicle condition
    Engine is running
    Air conditioning switch: ON
    Blower switch: LO

    Standard:
    Tester Connection
    Condition
    Specified Condition
    D37-8 (LOCK) - D37-13 (SG-2)
    Engine is running
    Air conditioning switch: ON
    Blower switch: LO
    Pulse generation

    Result:
    Result
    Proceed to
    NG
    A
    OK (When troubleshooting according to PROBLEM SYMPTOMS TABLE)
    B
    OK (When troubleshooting according to DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER
A


3.INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR)


    E152688E03
  1. Disconnect the connector from the air conditioning compressor.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B45-2 (SSR+) - B45-5 (SSR-)
    20°C (68°F)
    160 to 320 Ω



NG
REPLACE COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR)
OK


4.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - A/C LOCK SENSOR)


    E143742E74
  1. Disconnect the connector from the air conditioning amplifier.



    E152687E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D37-8 (LOCK) - B45-2 (SSR+)
    Always
    Below 1 Ω
    D37-13 (SG-2) - B45-5 (SSR-)
    Always
    Below 1 Ω
    D37-8 (LOCK) - Body ground
    Always
    10 kΩ or higher
    D37-13 (SG-2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER