TIRE PRESSURE WARNING RESET SWITCH > INSTALLATION |
| 1. INSTALL TIRE PRESSURE WARNING RESET SWITCH |
![]() |
Engage the 2 claws to install the tire pressure warning reset switch to the driver side knee airbag.
| 2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY |
Check that the ignition switch is off.
Check that the battery negative (-) cable is disconnected.
![]() |
Install the DLC3 to the driver side knee airbag assembly with the 2 claws.
![]() |
Connect the driver side knee airbag connector and tire pressure warning reset switch connector to the driver side knee airbag assembly.
![]() |
Support the driver side knee airbag assembly with one hand as shown in the illustration.
![]() |
Temporarily install the driver side knee airbag assembly with the 2 hooks.
![]() |
Install the driver side knee airbag assembly with the 4 bolts.
| 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System) |
![]() |
Connect the hood lock control cable assembly.
Connect each connector.
Engage the 3 claws and 10 clips.
Install the lower instrument panel finish panel sub-assembly with the 2 bolts <B>.
| 4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System) |
![]() |
Connect the hood lock control cable assembly.
Connect each connector and the aspirator duct.
![]() |
Engage the 3 claws and 10 clips.
Install the lower instrument panel finish panel sub-assembly with the 2 bolts <B>.
| 5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH |
![]() |
Engage the claw and clip, install the cowl side trim sub-assembly LH.
Install the clip.
| 6. INSTALL FRONT DOOR SCUFF PLATE LH |
![]() |
Engage the guide and the 8 claws, and install the front door scuff plate LH.
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. INSPECT TIRE PRESSURE WARNING SYSTEM |
| 9. INSPECT SRS WARNING LIGHT |