POWER STEERING SYSTEM > PRECAUTION |
| System Name | See procedure |
| Power Back Door System |
Click here
|
| 1.IGNITION SWITCH EXPRESSIONS |
| Switch Type | Ignition Switch (position) | Engine Switch (condition) | |
| Expression | Ignition switch off | LOCK | Off |
| Ignition switch on (IG) | ON | On (IG) | |
| Ignition switch on (ACC) | ACC | On (ACC) | |
| Engine start | START | Start | |
| 2.HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM |
The vehicle is equipped with an SRS (Supplemental Restraint System) such as airbags. Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident.
Before servicing (including inspection, replacement, removal and installation of parts), be sure to read the precautionary notices for the Supplemental Restraint System (Click here).
| 3.PRECAUTIONS FOR REMOVAL, INSTALLATION AND REPLACEMENT OF ELECTRONIC POWER STEERING COMPONENTS |
Be sure to align the front wheels straight ahead when removing and installing the power steering gear assembly.
If disconnecting the steering sliding yoke sub-assembly and the pinion shaft of the power steering gear assembly, be sure to place matchmarks before starting the operation.
| 4.HANDLING PRECAUTION |
When handling the electronic parts:
When handling the steering column:
When disconnecting and reconnecting the connectors:
When disconnecting the connectors related to the power steering system, turn the ignition switch on (IG), center the steering wheel, turn the ignition switch off, and then disconnect the connectors.
| 5.PRECAUTIONS FOR CAN COMMUNICATION |
CAN communication lines are used to receive information from the skid control ECU and the ECM, and to transmit warnings to the combination meter.
When there are any problems in the CAN communication lines, CAN communication system DTCs are output.
Perform troubleshooting for the communication line problems when the CAN communication DTCs are output. Be sure to start troubleshooting on the power steering system after confirming that the CAN communication system is normal.
Since the CAN communication line has its own length and route, it cannot be repaired temporarily with a bypass wire, etc.