Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

DTC    U0230    Lost Communication with Rear Gate Module

for Preparation Click here


DESCRIPTION


DTC No.
Symptom
Trouble Area
U0230
No communication from back door ECU continues
  1. Power source circuit of back door ECU
  2. Back door ECU branch wire and connector
  3. Back door ECU

HINT:
For vehicles with power back door system only.


WIRING DIAGRAM


C169770E03


INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the doors. If any doors need to be opened in order to check the connectors, open the doors and leave them open.

HINT:
  1. Operating the ignition switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.

1.CHECK FOR DTC
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Check for DTC.

    HINT:
    If the CAN MS bus communication error DTC U1002 is output, troubleshooting for U1002 and check for malfunctions in the CAN MS bus.

    Result:
    Result
    Proceed to
    DTC U1002 is not output
    A
    DTC U1002 is output
    B



B
GO TO GO TO DTC CHART (U1002) (Click here)
A


2.CHECK CAN BUS LINE FOR DISCONNECTION (BACK DOOR ECU BRANCH WIRE)
  1. Disconnect the back door ECU connector.



    C169769E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    O15-6 (MPX1) - O15-5 (MPX2)
    Ignition switch off
    108 to 132 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO POWER SLIDE DOOR ECU RH (MPX1, MPX2)
OK


3.CHECK WIRE HARNESS


    C169769E03
  1. Disconnect the back door ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    O15-11 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    O15-12 (B) - Body ground
    Always
    10 to 14 V
    O15-8 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BACK DOOR MOTOR UNIT (BACK DOOR ECU) (Click here)