Sequence
| Operation
| Description
| Duration
|
-
| ECM activation
| Activated by soak timer, 5 hours (7 or 9.5 hours) after ignition switch is turned off.
| -
|
A
| Atmospheric pressure measurement
| Vent valve turned is OFF (vent) and EVAP system pressure is measured by ECM in order to register atmospheric pressure. If pressure in EVAP system is not between 70 kPa and 110 kPa (525 mmHg and 825 mmHg), ECM cancels EVAP system monitor.
| 10 seconds
|
B
| First 0.02 inch leak pressure measurement
| In order to determine 0.02 inch leak pressure standard, vacuum pump creates negative pressure (vacuum) through 0.02 inch orifice and then ECM checks if vacuum pump and vent valve operate normally.
| 60 seconds
|
C
| EVAP system pressure measurement
| Vent valve is turned ON (closed) to shut EVAP system. Negative pressure (vacuum) is created in EVAP system, and then EVAP system pressure is measured. Write down measured value as they will be used in leak check. If EVAP pressure does not stabilize within 15 minutes, ECM cancels EVAP system monitor.
| 15 minutes*2
|
D
| Purge VSV monitor
| Purge VSV is opened and then EVAP system pressure is measured by ECM. Large increase indicates normal.
| 10 seconds
|
E
| Second 0.02 inch leak pressure measurement
| After second 0.02 inch leak pressure measurement, leak check is performed by comparing first and second 0.02 inch leak pressure standards. If stabilized system pressure is higher than second 0.02 inch leak pressure standard, ECM determines that there is a leak in EVAP system.
| 60 seconds
|
F
| Final check
| Atmospheric pressure is measured and then monitoring result is recorded by ECM.
| -
|
The monitor will run whenever these DTCs are not present
| None
|
Atmospheric pressure
| 70 to 110 kPa (525 to 825 mmHg)
|
Battery voltage
| 10.5 V or more
|
Vehicle speed
| Less than 2.5 mph (4 km/h)
|
Ignition switch
| off
|
Time after key-off
| 5 or 7 or 9.5 hours
|
EVAP pressure sensor malfunction (P0450, P0452, P0453)
| Not detected
|
EVAP canister purge valve
| Not operated by scan tool
|
EVAP canister vent valve
| Not operated by scan tool
|
EVAP leak detection pump
| Not operated by scan tool
|
Both of the following conditions 1 and 2 are set before key-off
| -
|
1. Duration that vehicle driven
| 5 minutes or more
|
2. EVAP purge operation
| Performed
|
Engine coolant temperature
| 4.4 to 35°C (40 to 95°F)
|
Intake air temperature
| 4.4 to 35°C (40 to 95°F)
|