NAVIGATION SYSTEM > Vehicle Speed Signal Circuit between Navigation Receiver Assembly and Combination Meter |

| 1.INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM) |
![]() |
Check the output waveform.
Remove the combination meter assembly with the connector still connected.
Connect an oscilloscope to terminals E1-9 (+S) and body ground.
Ignition switch on (IG).
Turn the wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
| Item | Condition |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Driving at approx. 20 km/h (12 mph) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - COMBINATION METER) |
![]() |
Disconnect navigation receiver assembly connector E5 and combination meter connector E1.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E5-3 (SPD) - E1-9 (+S) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - JUNCTION CONNECTOR) |
![]() |
Disconnect junction connector E24.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E24-3 - E5-3 (SPD) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||