REAR SPEED SENSOR (for 2WD) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR WHEEL |
| 3. SEPARATE REAR SPEED SENSOR WIRE |
![]() |
Using a screwdriver, disconnect the connector from the rear speed sensor.
| 4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the 2 bolts and separate the rear disc brake caliper assembly.
| 5. REMOVE REAR DISC |
![]() |
Put matchmarks on the rear disc and the axle hub.
![]() |
Release the parking brake and remove the rear disc.
| 6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY WITH REAR SPEED SENSOR |
![]() |
Remove the 4 bolts and the rear axle hub and bearing assembly.
| 7. REMOVE REAR SPEED SENSOR |
Install the 3 hub nuts and mount the rear axle hub and bearing assembly in a vise using aluminum plates.
![]() |
Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
![]() |
Using SST and 2 bolts (diameter: 12 mm, pitch: 1.5 mm), remove the rear speed sensor from the rear axle hub and bearing assembly.